Tymetal Corp. TYM-VSA, Инструкция по установке и эксплуатации, Страница: 5 / 36

TYM-VS2 Slide Gate Operator Installation Guide
- 3 -
Revision 0, 072012
The gate operator mounts to posts secured in concrete
footings. The posts support the operator and prevent it from
moving during operation, as shown in Figure 2.
Gate Preparation
Before installing, make sure the gate rolls or slides freely,
and that all exposed rollers are properly covered. The gate
must be covered with fabric with openings no larger than
2-1/4” in size, to a minimum height of 72” above ground
level. On picket-style gates, if pickets are spaced less than
2-1/4” apart, mesh is optional.
Use two 4” OD galvanized posts and secure with concrete
footings as shown, length to be determined by local codes,
frost line depth and soil conditions.
Attach the operator with the hardware provided.
To assemble the drive chain and chain support brackets,
refer to Pages 4 and 5. Make sure that the chain sag does
not exceed recommended dimensions and that the chain
does not come into contact with the moving parts of the gate
or ground.
WARNING
The operator is intended for installation only on gates
used for vehicles. Pedestrians must be supplied with
a separate access opening. The pedestrian access
opening shall be designed to promote pedestrian
usage. Locate the gate such that persons will not
come into contact with the vehicular gate during the
entire path of travel of the vehicular gate.
WARNING
The gate must be installed in a location so that enough
clearance is supplied between the gate and adjacent
structures when opening and closing to reduce the
risk of entrapment.
Vent Plug Installation
In order to keep gear oil from spilling out during shipping,
gear reducers used in gate operators have either a solid
plug, or a sealed vent plug, installed at the factory.
For operators with a solid plug, replace the solid plug with
the vent plug provided (see Figure 3).
With the vent plug installed, remove the vent plug’s breather
pin to allow the gear box to vent (see Figure 3)
Figure 3. Vent Plug Installation
Figure 2. Operator Elevations and Dimensions