Tymetal Corp. TYM-VSA, Инструкция по установке и эксплуатации, Страница: 28 / 36

TYM-VS2 Slide Gate Operator Installation Guide
- 26 -
Revision 0, 072012
-
During abnormal operation, the Controller’s displays and
beeper will indicate the error condition that has occurred.
Entrapment or Obstruction
If an entrapment condition occurs detected by two repeated
open or close obstruction triggers, the Controller will lock
the operator out. The beeper will sound constantly and the
gate will not operate. To reset the Controller press the
STOP
button or press the RESET button on the operator’s cover.
COMM LINK Connection Failure
In dual gate installations, if there is a connection failure
between the two operators, the
COMM LINK indicator will
blink once a second. During this condition the gate will not
operate, except if triggered by the
FIRE DEPT input, which
functions normally.
MGT Obstacle Transmitter Trouble
If any MGT transmitters are used with the operator, their
supervision feature will alert the Controller if there is any
trouble with the transmitter. MGT transmitters send hourly
status reports and will send low battery reports when the
transmitter has a low battery. The MGT transmitters also
have a tamper detection switch that will trigger when their
case is opened.
When the Controller detects a low transmitter battery, a
tamper signal, or missing transmitter status reports, the
gate will still operate normally, but the beeper will change
as follows:
Correct the trouble (close case, replace battery, or replace
transmitter) to clear the obstacle transmitter trouble
indications.
Maximum Run Time Exceeded
If the Maximum Run Time is exceeded, the Controller
stops the operator the same as if a double obstacle has
occurred in an entrapment condition. The entrapment alarm
sounds constantly, and is cleared by pressing the
STOP
button or the RESET button on the cover. After the STOP
or RESET button is pressed, because the Maximum Run
Time has been exceeded, the sounder will beep twice every
indication.
CONTROLLER ERROR CAUSES AND INDICATIONS
ERROR CAUSE ERROR INDICATION HOW TO CLEAR
En 00
En 01 MAX RUN
En 02 MAX RUN
En 03 COMM LINK
En 04
En 05
En 06
En 07
En 08
En 09
En 10
En 11
En 12
En 13
En 14
WARNING
The Stop and/or Reset button must be located in the
line-of-sight of the gate. Activation of the reset control
shall not cause the operator to start.