TYM T264, Руководство по ремонту

Страница: 39 / 215

11) Wedge both sides of the front axle to prevent
the engine from tilting.
12) Remove the clutch housing and engine
tightening bolts and move the engine forward.
FIG.2-22 Engine and HST
(2) Engine separation from the chassis.
When separating the engine from the chassis,
the following steps are required as well as the
ones mentioned above.
1) Lift the engine with the hoist and hold the front
axle bracket with a stands or the like.
2) Disconnect the upper, Lower ,and drain hoses
from the radiator.
3) Disconnect the two power steering system hoses.
4) Remove the fuel hose.
5) Disconnect the the inlet pipe.
6) Loosen the right hand pivot metal tightening
bolts beforehand.
7) Separate the engine from the front axle bracket.
(3) INSTALLATION
REASSEMBLY IN REVERSE ORDER OF
REMOVAL.
1) Install the engine on the front axle bracket.
2) Retightening the right hand pivot metal
tightening bolts.
3) Connect hoses.
4) Assemble the engine and the transmission.
Note:
-Apply small mount of grease to each of the
sliding parts.
-Be careful not to apply excessive amount of
grease as this could cause clutch slipping.
- During operation, be sure to avoid any of the
reassembly operations that may place load upon
the input gear.
5) Install the hydraulic system piping.
6) Install the dash panel.
7) Install the wiring and rods.
8) Install the covers.
9) Connect the panel set wiring and then install
the panel.
10) Connect the wiring for the engine.
11) Connect the battery terminals.
12) Install the engine hood.
2-10
FIG.2-20
FIG.2-21Wedging
Wedging