4
5
Read all instructions before using this appliance.
Save these instructions for future references
Approved for residential appliances
For residential use only
IMPORTANT SAFETY INSTRUCTIONS
CAUTION
FOR GENERAL VENTILATING USE ONLY. DO NOT USE
TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS
OR VAPORS.
WARNING
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an electrical
short circuit, grounding reduces the risk of electric shock by
providing an escape wire for the electric current. This appliance
is equipped with a cord having a grounding wire with a grounding
plug. The plug must be plugged into an outlet that is properly
installed and grounded.
WARNING - IMPROPER GROUNDING CAN
RESULT IN A RISK OF ELECTRIC SHOCK.
Consult
a
qualified
electrician
if
the
grounding instructions are
not completely understood, or if doubt exists
as
to
whether
the
appliance
is properly grounded.
Do not use an extension cord. If the power supply cord is too
short, have a qualified electrician install an outlet near the
appliance.
CAUTION
To reduce risk of fire and to properly exhaust air, do not
vent exhaust air into spaces within walls, ceilings, attics,
crawl spaces, or garages.
WARNING
TO REDUCE THE RISK OF FIRE, USE ONLY METAL
DUCT WORK.
Install this hood in accordance with all
requirements specified.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSONS, OBSERVE THE FOLLOWING:
Use this unit only in the manner intended by the
manufacturer. If you have questions, contact the
manufacturer
A.
B.
Before servicing or cleaning the unit, switch power
off at service panel and lock service panel disconnecting means to prevent
power from
being switched on accidentally. When the service disconnecting means
cannot be locked, securely fasten a prominent warning device, such as a
tag, to the service panel.
C.
Installation Work and Electrical Wiring Must Be Done
By Qualified Person(s) In Accordance With all
Applicable
Codes & Standards,
Including Fire-rated Construction.
D.
Sufficient air is needed for proper combustion and
exhausting of gases through the flue (Chimney) of fuel
burning equipment to
prevent back- drafting. F
ollow
he heating equipment manufacturers guideline
and safety standards such as those published by the National Fire Protection
Association (NFPA), the American Society for Heating, Refrigeration and Air
Conditioning Engineers (ASHRAE), and the local code authorities.
E.When cutting or drilling into wall or ceiling, do not
damage electrical wiring and other hidden utilities.
F.Ducted systems must always be vented to the outdoors.
WARNING
To Reduce The Risk Of Fire Or Electric Shock, Do
Not Use This Hood
With Any External Solid State
Speed Control Device.
WARNING
WARNING
Unplug or disconnect the appliance from the power supply
before servicing.
TO REDUCE THE RISK OF INJURY TO PERSONS, IN THE EVENT OF A
RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:
A.
SMOTHER FLAMES with a close - fitting lid, cookie sheet, or other metal
tray, then turn off the gas burner or the electric element.
BE CAREFUL TO
PREVENT BURNS
. If the flames do not go out immediately,
EVACUATE
AND CALL THE FIRE DEPARTMENT.
B.
NEVER PICK UP A FLAMING PAN
- you
maybe
DO NOT USE WATER
,
including wet dishcloths or towels - a violent steam explosion will result.
Always leave safety grills and filters in place.Without these components,
operating blowers could catch onto hair, fingers and loose clothing.
The manufacturer declines all responsibility in the event of failure to observe
the instructions given here for installation,maintenance and suitable use of the
product. The manufacturer further declines all
responsibility
for injury due to
negligence and the warranty of the unit automatically expires due to improper
maintenance.
STAINLESS STEEL FILTERS
About Your New Filters
Stainless Steel Baffle Filters do not need linings or mesh inside of the filters and
are completely constructed out of stainless steel. The stainless steel construction
allows them to be used
again after being cleaned or going through the
dishwasher.
How do Baffle Filters Work?
They function by forcing the grease filled air to quickly and continuously change
direction as it passes through the filter. The grease is unable to change direction
as fast as the air carrying them, they end up getting caught on the metal blades
and then trapped into the filter tray.These filters are both efficient and require less
maintenance.
IMPORTANT SAFETY INSTRUCTIONS
