RANGE HOOD INSTALLATION
RANGE HOOD INSTALLATION
D
E
t
一
一
1
(Outer Chimney)
臣三．
Core Body
WALL
Step 3:
Locate the 6" round aluminum duct (F) and
attach it to the top air outlet on the main body
of the range hood with HVAC foil tape
(not included). Make sure it is connected
tightly
Step 4:
Place the bottom of Outer Chimney into Core
Body's seating located near vent hole
Then Insert the Inner Chimney cover into the
Outer Chimney Cover.
Note that the Inner Chimney cover must slide
into the Outer Chimney cover's orientation slot.
(see step 7 for mounting bracket install)
Step 5:
A.Extend the inner chimney cover to the
height at which it will touch the ce由ng
id
. Usin
th
g
e
a
pencil, place a small mark on each s e of
chimney cover which is level with the screw holes
of the chimney. Now slide the inner chimney
cover down
B. Using a pencil, place a small mark on the wall
on each side of the chimney
C. Align the middle of the Inner chimney
bracket (H) with the drawn line and make
a mark where each screw hole in your
wall will need to be drilled for mounting of
the bracket
D. Drill 1 /4" holes at each marked location
The drilled hole should be slightly smaller
than the diameter of the anchor
E. Insert anchors into each drilled hole
F. Align Inner chimney bracket (H) with the
drilled holes and firmly screw it into place
』
111
,v
B
＼
A
i
r
outlet
A
B
Use 3/8"
三
g
10
惫
Installations :
Measure the distance between stove top and the
bottom of range hood. A distance of 24" to 32" is
recommended*. *Due to different ceiling height
configurations, recom-mended height may not be
applicable.
I. mark the
leveling
point of the hood. Position
two mounting screws on the wall, leaving 1/8"
space away from the wall.
2. Measure the width of the chimney then attach
the
chimney
-mounting brackets to the wall as
high as you want the upper chimney to be.
NOTE: Use threaded drywall anchors only
when
mounting
the hood on sheet rock.
Mounting the hood on wall studs or
lumbar
is
highly recommended
.
3. Align hood-mounting holes to the screws on
the wall and hook the hood into place. Tighten
screws to secure hood to the wall.
CAUTION: Make certain the range hood is
secure before releasing!
SAFETY WARNING: Risk of electrical shock. This range hood must be properly
grounded. Make sure this is done by
qualified
electrician in accordance with all
applicable national and local electrical codes. Before connecting wires, switch power
off at service panel and lock service panel to prevent power from being switched on
accidentally.
6. Store excess wires in the wiring box.
7. Install both chimneys and tighten screws to secure the lower chimney to the range hood
as shown in Figure 5.
8. To avoid scratching the chimney, extend the upper chimney slowly and carefully to the
chimney-mounting bracket and tighten screws as shown in Figure 6.
10
11
5. Connect the range hood to a designated standard outlet (please refer the product label
for the suitable voltage of this unit) or cut off the plug and connect three wires to house
wires and cap with wire connectors. Connect according to colors.
4.Connect the venting duct between the hood and the exhaust opening either on the
ceiling or wall. Use aluminum tape to make all joints secure and air tight.
