Ceiling:
•
Lift the ceiling up and place it carefully on the five (5) panels as shown below.
•
Note: Ensure that the (3) electrical connections – 1 on the front panel and 2 on the rear left panel –
are placed through the ceiling and are not disconnected when you put the ceiling into position slowly.
•
Tip: To make it easier to pull cables through the ceiling slot, you can take small styropor blocks and
put them on several places between the ceiling and the panels so that the ceiling stays put in an
elevated position. When the cables have been pulled through, remove the styropor blocks and lower
the ceiling onto the panels.
•
Lower the ceiling carefully onto the 4 wall panels.
Doors:
•
Put the fixed right hand side section attached to the door into the floor slot provided.
•
Align the door vertically to the ceiling edge until it touches the ceiling section.
•
Lift the ceiling section up and place the fixed side section into the ceiling slot provided.
•
Open the ceiling flap and turn the wooden locking device 90º in order to fix the glass sections.
In this way the side sections are firmly fixed to the ceiling. This ensures that the glass section
is firmly inserted into the door.
Page 9
