Tyco Deluge Red-E, Руководство по установке

Страница: 31 / 82

26
Remote Resetting Deluge Valve Setting Procedure
Perform Steps 1 through 13 when initially setting the TYCO DV-5A Valve with Remote-Resetting Trim
for service or after an operational test of the fire protection system (Ref. Figure 10).
Step 1. Close the System Main Control Valve (2).
Step 2. Close the Diaphragm Supply Valve (5).
Step 3. Open the Main Drain Valve (4) and System Drain Valve (23). Close the System Drain Valve
(23) after water ceases to discharge. Leave the Main Drain Valve (4) open.
At this time make certain that the Pressure Gauge Valves and the Alarm Control Valve (OP1), as
applicable, are open.
Step 4. Depress the plunger of the Automatic Drain Valve (3) to verify that it is open.
Step 5. Clean the Diaphragm Supply Strainer (13) by removing the clean-out plug and strainer basket.
The Diaphragm Supply Strainer (13) may be flushed out by momentarily opening the Diaphragm
Supply Valve (5).
1 DV-5A Valve Auto.
2 System Main Control Valve N.O.
3 Automatic Drain Valve Auto.
4 Main Drain Valve N.C.
5 Diaphragm Supply Valve N.O.
6 NOT USED
7 Solenoid Valve N.C.
8 Manual Control Station N.C.
9 Alarm Test Valve N.C.
10 Drip Funnel Drain
11 Water Supply Gauge
12 Gauge Test Valve N.O.
13 Diaphragm Supply Strainer
14 Diaphragm Supply Check Valve Auto.
15 Diaphragm Gauge
16 System Riser
17 Drain Header
18 Supply Header
19 Waterflow Pressure Switch
20 Water Motor Alarm Connection
21 Downstream Shut Off Valve N.O.
22 Funnel Drain Check Valve Auto.
23 System Drain Valve N.C.
OP 1 Alarm Control Valve (Optional) N.O.
Figure 7 Remote Resetting Deluge Electric Schematic Piping Diagram