Tyco Deluge Red-E, Руководство по установке

Страница: 27 / 82

22
Setting the Valve
NOTE
It is normal for the control panel to indicate various supervisory conditions related to supervised
valve position and system air pressure while the valve is being set. These may be silenced by
pressing on the “Buzzer Silence” button.
Deluge Valve Setting Procedure
Perform Steps 1 through 13 when initially setting the TYCO DV-5A Valve, after an operational test
of the fire protection system, or after system operation due to a fire. Refer to Figures 7, 8, or 9,
as applicable.
Refer to Tyco Fire Products technical data sheet TFP1306 for complete maintenance, testing and
compliance requirements. For electrically actuated releases, make sure to replace any heat detectors
that may have been affected by heat, clean or replace any smoke detector heads affected by smoke
and to clear all smoke prior to resetting the control panel. Follow the instructions in the Installation,
Operation and Instruction Manual for the Potter PFC-4410RC f or complete resetting instructions.
1 DV-5A Valve Auto.
2 System Main Control Valve N.O.
3 Automatic Drain Valve Auto.
4 Main Drain Valve N.C.
5 Diaphragm Supply Valve N.O.
6 Manual Reset Actuator
7 Wet Pilot Line Connection
8 Manual Control Station N.C.
9 Alarm Test Valve N.C.
10 Drip Funnel Drain
11 Water Supply Gauge
12 Gauge Test Valve N.O.
13 Diaphragm Supply Strainer
14 Diaphragm Supply Check Valve Auto.
15 Diaphragm Gauge
16 System Riser
17 Drain Header
18 Supply Header
19 Waterflow Pressure Switch
20 Water Motor Alarm Connection
21 Downstream Shut Off Valve N.O
22 Funnel Drain Check Valve Auto.
23 System Drain Valve
OP 1 Alarm Control Valve (Optional) N.O.
Figure 4 Deluge Wet Pilot Schematic Piping Diagram