Tyco Deluge Red-E, Руководство по установке

Страница: 10 / 82

5
IMPORTANT
•
For models equipped with compressors, read and understand the complete General Air Products,
Inc. Oil-Less Compressor Instruction Sheets which were provided in the documentation package
with this unit before connecting electrical wiring to the compressor
or attempting to set the valve.
•
For models equipped with integrated releasing panels read and understand the complete
Installation, Operation and Instruction Manual for the Potter PFC-4410RC which was provided in
the documentation package with this unit before connecting electrical wiring
or attempting to set the valve
.
• For Red-E Cabinet units equipped with an integral releasing panel, verify detector compatibility
with the Model PFC-4410RC 2-Wire Detector Compatibility Data which is
affixed to the door of the control panel before installing detection devices.
Some designers call for a bell or siren upon detection with strobe light or distinctive tone
to signal water flow. Check with the system designer to determine which signaling devices your
system requires.
Remote signals may be required on your system. Check with the system designer
to determine if remote signals are required.
Red-E Cabinet DV-5A units provide pre-connected wiring to the trim devices and allow for the
field connection of external system devices such as heat or smoke detectors, visual and audible
signaling devices, remote panels or equipment shutdown relays, etc. Each unit is provided with
a wiring schematic on the inside of the main door which indicates the pre-connected and field
wired circuits. The wiring schematics for Deluge, Single Interlock Preaction, Double Interlock
Preaction Electric are reproduced below for easy reference. Complete wiring instructions are
provided in the
Installation, Operation and Instruction Manual for the Potter PFC-4410RC.
The wiring diagrams for models without integral release panels are located in Appendix A.