Tyco CIM800, Руководство по установке

Страница: 2 / 8

2/8 Installation Instructions Doc. version 4.0
MZX CIM800 MZX Fire detection system
 Two spur circuits (Class B) monitoring single
normally closed contacts, with short circuit
giving a fault output.
 Single loop circuit (Class A) monitoring a nor-
mally open contact, with short circuit giving a
fault output.
 Single loop circuit (Class A) monitoring a nor-
mally closed contact, with short circuit giving
a fault output.
 Two spur circuits (Class B) monitoring multi-
ple normally open contacts, with short circuit
giving an alarm.

Single loop circuit (Class A) monitoring multi-
ple normally open contacts, with short circuit
giving an alarm.
Features
The CIM800 monitoring features include the fol-
lowing configurable items:
 Identifies all monitored contacts and signals to
the Fire Controller, the status of monitored
contacts and wiring to the contacts.
 Can monitor a single normally closed contact.
 Can monitor two Class B spur circuits, or a sin-
gle class Class A loop circuit.
 When two Class B spur circuits are con-
nected, each must be of the same style. A
monitored contact going to the active state, on
either spur circuit, will cause the CIM800 to
report the Active State back to the MX control-
ler.
 An LED reports the CIM800 status to the user.

The LED lights when the contact monitored by
the CIM800 has switched to the active (off
normal) state.
 The LED when normally off, will pulse when
the CIM800 is polled by the controller.
Wiring notes
Mounting
Installation of modules into an ANC-
8 ancillary housing
The housing can accommodate up to eight ancil-
lary PCBs. A stacking kit is available if a second
layer of PCBs is required.
How to install MX800 modules into an
ANC-8 ancillary housing
1 Assemble the required ancillary PCBs onto the
chassis plate as required, fixing as shown in Fig. 3.
2 Assemble the chassis plate into the housing and
secure using fixing screw, see Fig. 2.
NOTICE

There are no user- circuit required set-
tings (such as switches or headers) on
the CIM800.

All wiring must conform to the current
edition of IEE Wiring Regulations and
BS5839 part 1.

All conductors to be free of earths.

Fit the PCB to the M520 cover/ANC-8
ancillary housing.

Connect wiring to the monitored con-
tact. For CIM800 typical wiring config-
urations (see Figures 6 to 11).

Verify the correct polarity of wiring
before connecting the CIM800 to the
addressable loop