F3200/NDU AS4428.1 Installation Manual
Document No: LT0255
System Description
Page 2-6
5 July 2016
Issue 1.22
2.2
PHYSICAL STRUCTURE
The F3200 has a rugged, lockable painted steel cabinet, which houses 19 inch rack-mount
equipment and comes in two height options (both have the same width and depth). The
standard cabinet accommodates 15U total and the small cabinet accommodates 8U (where
1U = 1 3/4" = 44.5mm).
The Operator Display has a screened, polyester overlay mounted on a hinged inner door
fitted to the top 4U position. The Controller/Display pcb mounts directly to the rear of this
door.
Standard Cabinet
In the standard cabinet the space below the 4U Operator Display panel is covered by a
blanking plate, but there is provision for mounting other equipment (e.g. a 7U hinged inner
door for a mimic, or 16 Zone LED Display Bds), in place of this blanking plate.
There is provision for mounting additional equipment in the bottom 4U (e.g. an ASE rack),
but this might encroach on battery space.
The outer door has a large acrylic window to allow viewing of the equipment inside.
Four versions of FIP are available in this cabinet. The FP0781 and FP0783, which cater for
up to 64 zones, have a Cardframe fitted to the rear wall as shown in Fig 2.2.1. The FP0780
and FP0782 have provision (PCB stand-offs) for mounting up to three 8 way modules (i.e. 3
x 8 Zone or 8 Relay Modules) on the rear wall. All of these panels are supplied with one 8
Zone Module fitted.
Small Cabinet
In the small cabinet, only 1U (of the 4U) below the 4U Operator Display is visible through the
outer window. The gap is covered by a blanking plate (2U), which can be replaced by a
bracket for mounting a limited range of equipment, e.g., a 1U ASE bracket, or a 1U 1 Zone
Gas Control Panel.
A 6A PSU or a 7U LED Display door cannot be fitted, but the 4U 80 zone door (ME0457)
can be (note reduces battery space).
Up to four 8 way modules can be mounted on the rear wall, but the bottom two of these
share space with the batteries. Mounting arrangement and maximum capacity are shown in
Fig 2.2.2.
Only one FIP is available (FP0784), and this comes with one 8 Zone Module fitted (in the top
left position).
