MM-010019-001, Rev. B
49
12 SPEAKER
INSTALLATION
Select a location for the speaker that will allow for proper listening range with a moderate volume setting.
Total speaker cable length (of both cables) is approximately five (5) feet. Therefore, to include service
loops in the cables, the speaker must be mounted within approximately 4.5 feet of the control head.
1.
Install the speaker (Item 8 in Table 4-3) using the hardware and mounting bracket supplied with it.
Also refer to the instructions included in the speaker for additional mechanical installation
information.
2.
Route the speaker’s cable to the rear of the control head.
3.
Mate the Speaker Cable (Item 9 in Table 4-3) to the 2-pin connector at the rear of the control head by
visually aligning the ¾-moon-shaped keys of the connectors, and then pushing and turning the outer
locking ring of the cable connector clockwise until it stops. A mild click will be sensed to confirm
proper mating.
4.
Connect the speaker’s 2-pin plastic connector to the respective mating connector on the Speaker
Cable.
5.
Route the cables out of the way of casual contact, and tie and stow as necessary.
