MM-010019-001, Rev. B
25
radio installation and removal ease. A minimum distance of two (2) inches is recommended from the
front edge of the bracket. The bracket is front/back symmetrical, and left/right symmetrical.
As all installations differ, bracket-to-vehicle mounting screws are not included. Steel #10 self-threading
screws are recommended. Sheet metal screws should not be used. The bracket has ten (10) available
mounting holes; six (6) are underneath the radio when it is attached to the bracket. The following
mounting procedure is recommended:
1.
Using the Base Bracket (Item 1) as a template and/or the dimensional information shown in Figure
6-1, mark and drill mounting holes into the mounting surface as required. At least six (6) screws are
recommended for proper installation: Four (4) in the screw holes of the bracket’s side tabs and two
(2) in its center-most screw holes. If the installation prevents the installation of six screws, a
minimum of four screws installed in the side tabs’ holes is required.
SIDE & TOP VIEW
TOP VIEW WITH SCREW HOLE DIMENSIONS (In Inches)
Figure 6-1: Base Bracket (Radio Not Shown)
Side Mounting Tabs
(4 places)
Bracket-To-Vehicle
Screw Holes
(10 places)
Bracket-To-Radio Screw Holes
(6 places, 3 each side)
Four (4) Upper-Most
Holes Not Used
(2 each side)
