MM-010019-001, Rev. B
35
16.
Hook the second Fuse Block’s rail clip onto the DIN rail
next to the original Fuse Block and snap it in place.
When installed correctly, adjacent sides of the Fuse
Blocks will snap together as well.
17.
As shown in the photo at the right, install the Fuse Block
Jumper into adjacent slots of the two Fuse Blocks. DC
power distribution occurs through the jumper; therefore,
daisy-chaining of the supply-side wire-clamps is not
required. The Fuse Block from the Fuse Distribution
Accessory Kit has a protection marker installed on the
supply-side of the block to warn of inappropriate wire
installation in its supply-side wire-clamp.
18.
Press the Fuse Block Jumper firmly in place as shown in
the photo at the right.
19.
Reinstall the End Stop by hooking its rail clip onto the
DIN rail and snapping in the other side. Make sure it is
firmly against the second Fuse Block.
