12
http://www.tyan.com
Hot Plug for PCI-X Bus 2 (JP3005)
1
Enabled
1
Disabled
Use JP3005 to enable or disable Hot Plug functionality on PCI-X slots 2, 3, and 4.
Enabling Hot Plug will allow you to insert and remove 64-bit PCI expansion cards. OS
and chassis support required.
Enabled
= Close pins 2 and 3
Disabled
= Close 1 and 2
SMDC cable connector (J3004)
Pin
2
Pin
4
Pin
6
Pin
8
Pin
10
Pin
12
Pin
14
Pin
16
Pin
1
Pin
3
Pin
5
Pin
7
Pin
9
Pin
11
Pin
13
Pin
15
Pin
Signal Definition
Front Panel Connection Requirements
1
Buzzer Stop
Side A of normally open momentary switch
2
Buzzer Stop switch -
Side B of normally open momentary switch
3
BMC controlled power LED +
Anode of LED G
4
BMC controlled power LED -
Cathode of LED G
5
Back plane Hard drive ACT +
Anode of LED H
6
Back plane Hard drive ACT -
Cathode of LED H
7
ANY BMC reported ERR LED +
Anode of LED I
8
ANY BMC reported ERR LED -
Cathode of LED I
9
Raid back plane controller error +
Anode of LED J
10
Raid back plane controller error -
Cathode of LED J
11
ANY system fan error LED +
Anode of LED K
12
ANY system fan error LED -
Cathode of LED K
13
Any power supply error +
Anode of LED L
14
Any power supply error -
Cathode of LED L
15
System External error +
Anode of LED M
16
System External error -
Cathode of LED M
CMOS Reset (J4000)
Clear CMOS
Pin 5
Pin 6
Normal
Pin 5
Pin 6
You can reset the CMOS settings in case an incorrect setting causes system
instability or you have forgotten your system/setup password or have just flashed
your BIOS by using these jumpers.
- Power down the system
- Set jumper J4000 to Clear CMOS by closing pins 5 and 6 with a jumper shunt
- Power up the system
- The system will notify you that the CMOS has a bad checksum. Then, ask you to
press <F2> to reconfigure the CMOS or <F1> to continue to boot up the system
with the default values.
- Press <F2> to enter the CMOS setup and load BIOS optional defaults
- Save the CMOS and exit the CMOS setup.
- Power down system and remove the jumper shunt on Pin 5 & 6.
- The CMOS will be loaded with defaults during the next power-up.
