78
http://www.TYAN.com
Cache:
a temporary storage area for data that will be needed often by an application.
Using a cache lowers data access times, since the needed information is stored in the
SRAM instead of in the slow DRAM. Note that the cache is also much smaller than your
regular memory: a typical cache size is 512KB, while you may have as much as 4GB of
regular memory.
Cache size
: refers to the physical size of the cache onboard. This should not be confused
with the cacheable area, which is the total amount of memory, which can be scanned by
the system in search of data to put into the cache. A typical setup would be a cache size
of 512KB, and a cacheable area of 512MB. In this case, up to 512KB of the main memory
onboard is capable of being cached. However, only 512KB of this memory will be in the
cache at any given moment. Any main memory above 512MB could never be cached.
Closed and open jumpers:
jumpers and jumper pins are active when they are “on” or
“closed”, and inactive when they are “off” or “open”.
CMOS (Complementary Metal-Oxide Semiconductors):
chips that hold the basic
startup information for the BIOS.
COM port:
another name for the serial port, which is called as such because it transmits
the eight bits of a byte of data along one wire, and receives data on another single wire
(that is, the data is transmitted in serial form, one bit after another). Parallel ports transmit
the bits of a byte on eight different wires at the same time (that is, in parallel form, eight
bits at the same time).
DDR (Double Data Rate):
is a technology designed to double the clock speed of the
memory. It activates output on both the rising and falling edge of the system clock rather
than on just the rising edge, potentially doubling output.
DIMM (Dual In-line Memory Module):
faster and more capacious form of RAM than
SIMMs, and do not need to be installed in pairs.
DIMM bank:
sometimes called DIMM sockets, because the physical slot and the logical
unit are the same. That is, one DIMM module fits into one DIMM socket, which is capable
of acting as a memory bank.
DMA (Direct Memory Access):
channels that are similar to IRQs. DMA channels allow
hardware devices (like soundcards or keyboards) to access the main memory without
involving the CPU. This frees up CPU resources for other tasks. As with IRQs, it is vital
that you do not double up devices on a single line. Plug-n-Play devices will take care of
this for you.
Doze mode:
in this mode, only the CPU’s speed is slowed.
DRAM (Dynamic RAM): widely available, very affordable form of RAM, which has the
unfortunate tendency to lose data if it is not recharged regularly (every few milliseconds).
This refresh requirement makes DRAM three to ten times slower than non-recharged
RAM such as SRAM.
ECC (Error Correction Code or Error Checking and Correcting):
allows data to be
checked for errors during run-time. Errors can subsequently be corrected at the same
time that they’re found.
