TYAN S1682D, Руководство пользователя

Страница: 20 / 29

20 S1682D-001-02 http://www.tyan.com
4. Drop the Retention Module down over the
Pentium II Slot so that the Retention Module
seats flat against the motherboard. Tighten the
screws in a clockwise manner to secure the
module to the board. (Warning — Do not
overtighten the screws as you may damage
the module and/or the motherboard.)
Installing CPUs
5. When the Retention Module is securely installed, you are ready to plug the
CPU into the Retention Module. Make sure that the CPU's Cooling Fan is
turned away from the I/O connectors before you plug the CPU into the CPU
module.
6. Press firmly on the CPU until you hear a "click". The Pentium II CPU will
make a clicking sound when it is fully locked into the Retention Module.
7. After the CPU is securely seated on the Retention Module in the Pentium
II Slot , connect the CPU's Cooling Fan cable to the Cooling Fan power
Connector on the board.
3.2 Installing CPU Cooling Fans
8. Locate the Cooling Fan Connectors (2 Connectors: J20 and J23--1 for each
CPU) on the motherboard.
9. Plug the CPU's Cooling Fan Cable into the Cooling Fan Connector on
the board. Make sure that the black wire of the cable is plugged into Pin 1
of the connector. (Refer to Pin 1 marked on the layout on P10.) (Pin
Assignments: Pin 1: ground--black, Pin 2: 12 V--red, Pin 3: Signal--yellow.)
Retention Module