TYAN S1682D, Руководство пользователя

Страница: 21 / 29

21 S1682D-001-02
(Unlike Active Processors, Passive Processors are not equipped with
cooling fans. Passive
Processors are equipped
with heat sinks instead.)
Each CPU package should
also contain the following:
CPU Retention Module (x1)
Heat-sink Retention Bracket
with mounting locks (x1)
Mounting Attach-mounts (x 2)
Heat-sink Lock (x1)
3.4.1 Installing CPU
Retention Modules
1. When installing the CPU
Retention Module, make sure
that you have the appropriate
end of the module lined up with
the key notch on the Pentium II
Slot connector. This will
ensure that the module is in-
stalled properly.
2. Before tightening the screws, make certain that the module is flush
against the motherboard. If one end of the module is raised above the
board, check the orientation of the module.
3. Install the module on the board by turning the screws in a clockwise
direction. (Do not over tighten the screws).
3.4 Installation and Removal of Pentium II Passive Processors
Pentium II Passive CPU Module
Retention Module