![Twin-Star International 73702/23WM9083-PM92 Скачать руководство пользователя страница 9](http://html1.mh-extra.com/html/twin-star-international/73702-23wm9083-pm92/73702-23wm9083-pm92_instruction-manual_1184220009.webp)
8
ELECTRICAL CONNECTION
A 15-Amp, 120-V, 60 Hz circuit with a properly grounded outlet is required. Preferably, the fi replace will
be on a dedicated circuit as other appliances on the same circuit may cause the circuit breaker to trip or
the fuse to blow when the heater is in operation. The unit comes standard with 6-ft. three-wire
cord, exiting from the rear of the fi replace. Avoid using an extension cord. If an extension cord must be
used, it must be a minimum 14 AWG, three wire with grounding type plug connector and rated not less
than 1875 watts. The cord shall not be more than 20 ft. in length.
Cold climate installation recommendation: When installing this unit against a non-
insulated exterior wall or chase, it is mandatory that the outer walls be insulated to
conform to applicable insulation codes.
Fig. 6
Install
Insert
From
Back
Mounting
Bracket
Completed
Unit
Electric
Fireplace Insert
6. Remove the two mounting brackets attached to the
back of the Left and Right Front panels.
Set aside with the wood screws.
PLEASE READ ALL “ELECTRIC FIREPLACE
INSERT” INSTRUCTIONS PRIOR TO INSTALLING
ELECTRIC INSERT IN YOUR COMPLETED
FIREPLACE MANTEL. INSTALL THE INSERT IN
YOUR
FIREPLACE
Lift insert carefully into the back of the unit and
center in the insert opening. Do not drag insert
across Hearth/Base (A) as it may scratch your unit.
Install the mounting brackets to hold insert fl ush
against the inside of the mantel front panel.
MOVE YOUR COMPLETED UNIT ONLY SHORT
DISTANCES. MOVE COMPLETED UNIT WITH
GREAT CARE. IT TAKES TWO PEOPLE TO
MOVE COMPLETED UNIT INTO ITS FINAL
POSITION.
Fig. 5
5. Insert one Wood Dowel (CC) into the pre-drilled
holes on the top edges of the assembly from step
4. Insert Camlock (AA-1) into the predrilled holes
in the underside of the Mantel/Top (G), make sure
to tighten. Insert Camlock (AA-2) into the holes in
the Side Panels. Attach the Mantel/Top (G) fi nished
side up to the completed assembly. Use Phillips
head screwdriver to tighten Camlock (AA-2).
G
AA
CC
Hardware Used
AA
CC
Camlock
x 6
Wood Dowel
x 6