PREVENTIVE MAINTENANCE
–
G
AS
I
NFRARED
H
EATER
Routine maintenance should be performed at least once a year by a qualified service agency to
insure the heater is operating properly. Overtime, particularly during long periods of not being used,
the heater can accumulate dirt, debris and cobwebs in and around the pilot and the burner. More
frequent service may be required for heaters located near waterfronts or in strong wind areas were
there might be sand storms.
It is strongly recommended that the heaters be inspected annually, before each use season.
STAINLESS STEEL
The heater is made of non-rusting stainless steel. Certain areas may discolor overtime. This is a
normal discoloration caused by the intense heat given off by the burners. Use the mildest cleaner and
always scrub in the direction of the grain. Do not use steel wool to clean the surface. Never clean the
heater when it’s hot.
LEAK TEST
At the beginning of each fall/winter season and after filling and reattaching the propane tank, you
should test the unit for gas leaks using soap solution. Periodically inspect the connections for
corrosion. If you find a problem, contact your gas supplier for repairs.
SPIDER AND INSECT WARNING
Spiders and other insects can nest in the burner which can cause the gas to flow from the front of
the burner. This dangerous “condition” can cause a fire behind the valve panel, damaging the heater
and making it unsafe to operate. Inspect the burner once a year or if the heater has not been used for
more than one month.
ELECTRICAL SHOCK HAZARD
Disconnect electrical power and gas supply before servicing. This heater must be connected to a
properly grounded electrical source.
17
