twin busch TW SA 42 U V2, Инструкция по установке, эксплуатации и обслуживанию

Страница: 19 / 48

- 20
TWIN BUSCH GMBH
Technical changes, errors and printing mistakes are reserved. V01_NK_418_EN
4. Operation instructions
To avoid personal injury and/or property damage, permit only trained personnel to operate the lift. After reviewing these
instructions, get familiar with lift controls by running the lift through a few cycles before loading vehicle on lift. Always lift the
vehicle using both platforms. Never raise just one end, one corner or one side of vehicle.
The normal users are not allowed to open the door of control cabinet. Option switches in the control cabinet need to
be turned to ‘working’ before using the lift to raise vehicles
.
Using the Main Lift
Raising
1. Drive and park the vehicle midway between two platforms. Make sure the vehicle is correctly positioned and secured against
rolling.
2. Turn the optional switch on the control panel to “
Main Lift
”.
3. Push the “UP” button on the control panel to lift the vehicle a bit higher from the ground and check again if the vehicle is in a safe
position.
4. Having raised the vehicle to the height needed, push the “Safety Lock” button to ensure the mechanical safety lock is
engaged. Press the “Emergency Stop” and check again the stability before performing maintenance or repair work.
Lowering
1. Switch on.
2. Push ”DOWN I” button to lower the lift. Firstly, the lift will automatically rise to disengage the mechanical locks. Then the lift lowers.
It will stop lowering when clearance between the platforms and the ground reaches to 600mm.
3. Push “DOWN II” button to continue lowering the platforms. Alarming buzz will be heard.
Using the Auxiliary
lift Raising
1. Turn the optional switch on the control panel to “Auxiliary lift” .
2. Place rubber pads under the pick-up points of vehicle. When it is necessary to use the platform extensions, press “UP”
button to raise platforms of the jack a bit over the platforms of main lift and pull out the extensions.
3. Press “UP ” button and check again if the rubber pads are directly under the pick-up points of the vehicle, when they are very
close to the vehicle’s chassis.
4. Keep on pushing ”UP ” button until reaches to the desired height. Full rise of the jack is 450mm over the platform of main lift.
Lowering
Attention: in case the platform extensions of the auxiliary lift are used, the operator needs to push the
extension in after the four wheels of vehicle lay on the main platforms.
1. Turn the optional switch on the control panel to “Auxiliary lift” .
2. Push “ DOWN I” button on the control panel to lower the
jack. 3.Take away rubber pads.
The lift lowered
Press DOWN II when
platforms stop lowering at a
distance of 600mm above
ground