twin busch TW SA 42 U V2, Инструкция по установке, эксплуатации и обслуживанию

Страница: 15 / 48

- 16
TWIN BUSCH GMBH
Technical changes, errors and printing mistakes are reserved. V01_NK_418_EN
Do not place any vehicle on the lift in the case of trial running.
3. General Installation Steps
Step1: Choose installation site.
Use a fork lift to place the machine at installation site as required. See Annex 1 for space requirements on the installation site.
Step 2: Connect hydraulic oil hoses.
Connect the oil hose as per the scheme for oil hose connection. (This step is very important and it is quite necessary to
understand the diagram of oil hose connection before operation)
Step 3: Connect pneumatic hoses.
Connect the pneumatic release system by the scheme of pneumatic hose connection.
Step 4: Connect electrical wires.
Refer to the electrical connection scheme. Connect the power supply and the quick connecters for limit switch.
Step 5: Fill with hydraulic oil.
ONLY CLEAN AND FRESH OIL
ONLY
Attention:
Lift must be fully lowered before changing or adding hydraulic oil
Normally it needs 22 liters of hydraulic oil.
Initially, fill the tank full with about 18L of hydraulic oil . Run the main and the secondary lift for several cycles and add another
4L into the tank.
Note
：
As running speed of the lift is mainly decided by the density hydraulic oil, we suggest using NO.46 hydraulic oil when
average
Temperature of the location is above 18 degree Celsius and using NO.32 hydraulic oil when temperature is below 18 degree
Celsius.
Step 6: Leveling
Check the connection of the hydraulic and electrical system before leveling operation
Review operation instructions and get familiar with lift controls by running the lift through a few cycles before leveling operation.
Leveling platforms of the main lift
1) Turn on the main power switch and turn the selection switch SA2 to the main lift and SA1 to “Leveling” status. Turn the two
handles of leveling valve to the following status.
2) Push the UP button to raise the platforms to the max height and then lower to the minimum height. Repeat this for 3 cycles. Pay
attention to push the UP button very slightly and slowly when the platforms almost reach to the max height. After that, engage the
mechanical safety locks and push DOWN I and DOWN II to completely lower the platforms. This step may needs pretty long time
as there remained air in the oil cylinders and no load on the platforms.
3) Repeat the cycles of step 2 for two or three times. Turn off the two leveling valves when platforms are fully lowered. Turn the two
handles to the following status.