Tweco Spray Master Series, Инструкция по безопасности и эксплуатации, Страница: 22 / 36

16
SAFETY AND OPERATING INSTRUCTIONS
89200009
7.04 REPAIR OF CABLEHOZ®
A. Back-End Repair
1. Disassemble the rear case to expose the rear connector assembly and pull the assembly away from the rear
case.
2. Cut the Cablehoz to remove the damaged area.
3. Use replacement connector assembly, Part No.
MS172-RK (Stock No. 2060-2134) on 250 Amp
Spray Master MIG Guns and MS174-RK (Stock No.
2060-2135) on 350 & 450 Amp Spray Master MIG
Guns.
4. Measure back 2-1/2” (63.5mm) from the end of the Cablehoz and cut away the outer jacket of the cable,
being careful not to cut the copper strands and or lead wires.
5. Pull the copper strands and lead wires away from
the inner core tube that’s exposed and cut away
leaving approximately ¼” (6.35mm) past the end
of the end of the Cablehoz.
6. Cut the copper strands to a length of ¾” (19.05mm)
while leaving the wire leads intact.
7. Thread the pressure nut onto the replacement rear connector until it bottoms out and then slide the sleeve
over the connector. Note: Make sure that the end with the bevel on the inside diameter goes on first allowing
the opposite end with a ¾” (19.05mm) to be facing the Cablehoz when assembled.