9
5.3
RS-232 Protocol
The connection between MX-8488 and controller with RS-232 modem cable.
COMMAND
DESCRIPTION
A1 - A8
Switch output A to input 1 - 8
B1 - B8
Switch output B to input 1 - 8
C1 - C8
Switch output C to input 1 - 8
D1 - D8
Switch output D to input 1 - 8
E1 - E8
Switch output E to input 1 - 8
F1 - F8
Switch output F to input 1 - 8
G1 - G8
Switch output G to input 1 - 8
H1 - H8
Switch output H to input 1 – 8
ABCD...H1 – ABCD...H8
Switch selected outputs (ABCD… etc.) to
input 1 – 8 as a group
SETIP <IP> <Subnet> <Gateway>
Switches to Static IP mode and sets the IP,
Subnet and Gateway
RSTIP
Resets the IP configuration to DHCP mode
IPCONFIG
Display the current IP config
P0
Power off
P1
Power on
I1 - I8
Switch all outputs to input 1 - 8
ST
Display current matrix state and firmware
version
RS
System Reset
EM 1-2
Set EDID MODE (1 =STD, 2=TV)
?
Display all available commands
QUIT
Exit (Telnet only)
Notes:
1.
RS-232 commands will be not executed unless followed with a carriage return (CR) command and for some
systems a Line feed (LF) command. Commands are case-insensitive.
2.
If the Telnet connection is idle for more than 10 minutes the port will automatically be closed.
RS-232
Transmission Format:
Baud Rate: 19200bps
Data Bit: 8 bits
Parity: None
Stop Bit: 1bit
Flow Control: None
Remote Control
PIN
Assignment
1
NC
2
Rx
3
Tx
4
NC
5
GND
6
NC
7
NC
8
NC
9
NC
MX-8488
PIN
Assignment
1
NC
2
Tx
3
Rx
4
NC
5
GND
6
NC
7
NC
8
NC
9
NC
