TV One C2-6204, Руководство по эксплуатации

Страница: 53 / 105

C2-6204 S
ERIES
O
PERATION
M
ANUAL
48
Mode Function
Normal/weave The two interlaced fields are simply combined/weaved
together. This will often show artifacts on moving images,
but can be used when the input is known to be still.
Auto Automatically selects Film 3:2 or Medium Range Motion
Compensation (M. Comp Med.) depending on whether Film
Mode is detected or not.
Film 3:2 Enables 3:2 pull down conversion of the incoming NTSC
video. (This option should not be used if the source is not
NTSC video).
M. Comp Low
M. Comp Med.
M. Comp High
Enables Pixel Adaptive Motion Compensation. Three levels
are available with ‘Low’ providing the least compensation
for Motion and ‘High’ providing the most compensation.
Frame/bob The two fields are shown consecutively.
This menu item allows the user to specify whether the source has diagonal
interpolation applied to it when de-interlacing occurs. This reduces ‘jagged’ artifacts
on moving images, however is not suitable for noisy sources where the noise could
be mis-interpreted as a diagonal or sloping element of the picture.
This menu item allows the user to specify whether the source has noise reduction
applied to it. This is performed by averaging the video signal over a number of
fields – but ignoring areas where motion has occurred. If motion blurring is seen, it
is recommended to turn this setting off.
8.7.2 DVI Source Menu Items
HDCP is supported on certain units only - and only on the DVI input connector.
This menu item lets you change whether HDCP is active on this particular DVI
input.
If turned ‘Off’, then a source that requires HDCP encryption will not send a video
signal to your unit.
If turned ‘On’, and a HDCP-compliant display or device is attached to your unit’s
DVI output, then HDCP encrypted sources can be used.
The following table summarizes the message given in brackets:
Source : RGB1
Noise reduction
[Off]
Source: DVI1
HDCP [Inactive] [Off]
Source : RGB1
Diagonal interp.
[Off]