17
After binding a sensor with a camera, in order to make the host only send out SMS
alarm information but no MMS image when the sensor alarms, it is necessary to
remove the sensor from the camera(s).
Command:
The user must edit and send the following SMS command to the device in order
to:
Remove a sensor from the bound camera(s)
:
(7)
#41#SensorNumber#CameraNumber#.... CameraNumber#
Remove a sensor from all bound camera(s)
:
(8)
#41#SensorNumber#
•
SensorNumber
is in the range of “S1” to “S4”. It is the corresponding number
of the Sensor Signal Input on the host.
SensorNumber
can be replaced with
SensorDescription.
•
CameraNumber
should be a one-digit number and in the range of “1” to “4”. It
is the camera number which is bound with the sensor. A sensor can be bound
with up to eight cameras.
CameraNumber
can be replaced with
CameraDescription.
☺
Successful SMS reply:
Remove sensor ** from camera *(, camera*) successfully.
Remove all sensors from binding cameras.
3.6
Add or remove administrator number
3.6.1 Add an administrator number
Authority:
Super-Administrator
number.
Description:
Up to ten
Administrator
number can be added to the device. If an
Administrator
number be bound with a camera, it’ll receive the image captured by the camera.
Command:
The user must edit and send the following SMS command to the device in order
to:
Add the Administrator number bound with the camera(s)
:
(9)
#06# AdministratorNumber#CameraNumber#.... CameraNumber#
