GB
11
(3) Now pass the webbing up through the #4
(largest) slot at the end of the buckle. Feed
the webbing back underneath the buckle and
push it up through slot #1. (Fig. 13B)
(5) Excess webbing material may be cut from the
belt if desired.
1. Thread the cam buckle as shown in Figure (14 to 16).
2. Slide the backpack onto tank to desired position.
3. Cam belt should now be positioned as shown in Figure
17. Pull firmly on end of the belt until all slack has been
removed.
4. Once again check that the backpack is at desired position on tank.
5. To prevent slack of the belt while buckle is lifted, mate
the Hook and Loop fastener on the belt once in this
timing. (Fig. 18)
(Fig. 14)
(Fig. 15)
THREADING AND ADJUSTING TANK BELT
(Fig. 16)
(Fig. 17)
(Fig. 18)
(Fig. 13B)
