7
Turn of the Century
TM
ASSEMBLY INSTRUCTIONS
11
11. Raise the canopy, ensure the two mounting bracket
screws are aligned with the J-shaped slots in the canopy.
Then turn the canopy clockwise until the mounting
bracket screws are completely engaged in the J-shaped
slots. Install the two previously removed mounting
bracket screws in the round holes. Securely tighten all
four mounting bracket screws.
Canopy
Round
Hole
Mounting
Bracket
Screw
J-shaped Slot
Black (hot/power)
White (neutral)
Bare/Green
(ground)
Red
Whit
e
White
Whit
e
Blac
k
Blue
Blue
Black
Green
Gree
n
Receive
r
10. Secure all wiring connections together with wire
connectors according to the diagram and these steps:
• Connect the Green wires from the fan and the mounting
bracket to the Bare/Green (ground) supply wire.
• Connect the Blue wire with white label from the receiver to
the Blue fan wire.
• Connect the Black wire with white label from the receiver
to the Black fan wire.
• Connect the White wire with white label from the receiver
to the White fan wire.
• Connect the Red wire with red label from the receiver to
the Black (hot/power) supply wire.
• Connect the White wire with red label from the receiver to
the White (neutral) supply wire.
Important:
The Blue fan wire is power for the light. The
Black wire is power for the fan. The White wire is common/
neutral. The Green wire is the ground wire. If supply wires
are different colors than referred to above, a professional
electrician should determine proper wiring.
Wire Connector
10
9. Lift the downrod into the mounting bracket. Rotate the
downrod until the tab in the mounting bracket is seated in
the slot in the downrod ball.
WARNING:
The fan and/or downrod should not rotate in
the mounting bracket if installed correctly. Failure to align
the slot in the downrod ball with the tab may result in fan
falling causing serious injury or death.
Tab
Slot
Downrod
Mounting
Bracket
9
