Turin TU-SB-979-48-36-R, Инструкция по установке и эксплуатации

Страница: 79 / 118

1
C • j
LJ
Hanging the Door
ROLLER CAM ADJUSTMENT
Rotate the outer edge
of roller assembly usin-g-------��
the sma 11 hex,
while holding the
large hex wrench --­
in place.
--
II I
I
II I
I
End View
upper roller
assembly
top rail (2)
bottom roller
assembly
�
Suspend the sliding door (4) on the top rail (2). Position the bottom edge of sliding glass
door (
4)
into the groove of the sliding door track divider
(10).
Adjust the upper roller
assemblies (11) to insure the bottom edge of sliding glass door (4) does not touch the
bottom sliding door track divider ( 10). See roller cam adjustment drawing for details.
(The rollers for this unit have a built in cam adjustment to adjust the plumb of sliding door.
Locate the small hole in outside edge of roller assembly and insert a small hex wrench into
hole opening. Next using the hex wrench for roller assembly slightly loosen the roller
wheel assembly. Now holding the hex wrench in place rotate the outer edge of roller
assembly using the small hex wrench inserted into small hole opening in outer edge of
roller assembly. This will move the roller cam to offset any minor adjustments for sliding
door out of plumb. All 4 rollers on this unit can be adjusted as describe above).
Install the bottom roller assemblies (11) on the sliding door (4) to secure the sliding glass
door (4) to top rail (2). Adjust the bottom roller assemblies (11) to a gap of 1 /32". This gap
is a starting gap, check that the sliding door rolls smoothly along the top rail. Make
adjustments if needed.
19