Turin TU-SB-979-48-36-R, Инструкция по установке и эксплуатации

Страница: 17 / 118

2. Using the appropriate drill bit for your wall surface drill the hole location with a
5/16" diameter drill bit. Install the plastic anchors from screw pack 2 into the
drilled hole. See figure 2.
3. Attach the wall mount (7) to shower wall using MS x 40 screw from screw pack 2.
See figure 3.
4. Set properly check for level and plumb and then apply a small neat bead of 100%
clear silicone to the inside bottom of the Vertical channel (23) .Install fixed glass
(3) to Vertical channel (23) and Install Li-channel Seal (24) to fixed glass (3).
See figure 8.
5. Slide rail end (6) onto top rail (2) and loosely tighten into place. Note: The set
screws in rail end are not centered, and one end of rail end is threaded. The rail
end (6) should be installed on top rail (2) so that threaded end of rail end (6) is
facing outward. See figure 4.
6. Loosen set screws in rail mount receiver (8) and slide onto left end of top rail (2).
See figure 5.
ATTENTION: A minimum of two people are required for the next assembly steps.
7. Position top rail / fixed glass assembly into place in your shower opening. Next
align rail mount reciever (8) with brass fitting on inside of return glass panel (5),
and secure by tightening the rail mount receiver to brass fitting. Tighten set screws
in rail mount receiver (8) to secure to top rail (2) See figure 5 and 7-2.
8. Thread rail end (6) onto wall mount (7) and securely tighten. Tighten set screws in
rail end (6) to secure rail end to top rail (2). See figure 7-2.
9. Set properly check for level and plumb and then apply a small neat bead of 100%
clear silicone to the inside bottom of the Vertical channel (23) .Install fixed glass
(3) to Vertical channel (23) and Install Li-channel Seal (24) to fixed glass (3).
10. Insure plastic sliding door glide is in place in underside of sliding door track divider
(10) and positioned to proper location for 10mm glass thickness. See figure 9.
11. Position the sliding door track divider ( 10) into position as seen in figure 10 and
mark the 2 shower base hole positions. Note: In drawing 10 the hole locations
for attaching sliding door track divider should be 1 13/16" from edge of
fixed glass. See details in figure 10.
NOTE: If your surface is prone to cracking or chipping then it is recommended
that you pilot drill first using a smaller drill bit, and then step up to the final
size.
16