TURFCO T3100, Быстрое руководство по эксплуатации

Страница: 18 / 25

G730 9
Typically, an engine oil with a minimum rating
of 9.0 cSt (55 SUS) at 230° F (110° C) and an
20W50 engine oil has been selected for use
by the factory and is recommended for normal
operating procedures.
Fluid Volume and Level
Fluid volume information is provided in
the table below.
to be added or even replaced. Refer to page 11
operated for approximately 1 minute.
Purging will be required if oil has been changed.
Refer to the purging procedures on page 12.
Fluids
been carefully selected, and only equivalent, or
better products should be substituted.
Fluid Description
20W50 engine oil
Volume – per Transaxle
© 2015 HYDRO-GEAR
Turfco T3000, T3000i and T3100 Applicator
Transaxle Filter, Transaxle Fluid Changing and Purging
The following is from the Hydro-Gear® Transaxle Service and Repair Manual.
This section covers the changing of the transaxle filter, changing the transaxle
fluid and purging procedures.
Additional transaxle service and maintenance proceedures can be found in the
Turfco Maintenance and Service CD that came with your Turfco applicator. The
CD contains the entire Hydro-Gear entire transaxle manual.
12 G730
PURGING PROCEDURES
-
drostatic drive applications, it is critical that it is
purged from the system.
-
sion and expansion rate is higher than that of
the oil approved for use in hydrostatic drive
systems.
These purge procedures should be imple-
mented any time a hydrostatic system has been
opened to facilitate maintenance or the oil has
been changed.
The resulting symptoms in hydrostatic systems
may be:
1. Noisy operation.
2. Lack of power or drive after short term op-
eration.
3. High operation temperature and excessive
expansion of oil.
Before starting, make sure the transaxle is at
-
cations outlined in this manual.
The following procedures are best performed
with the vehicle drive wheels off the ground.
Then repeated under normal operating condi-
tions. If this is not possible, then the procedure
should be performed in an open area free of
any objects or bystanders.
1. Disengage the brake if activated.
2. With the bypass valve (freewheel) open
and the engine running, slowly move the
directional control in both forward and
reverse directions (5 or 6 times).
3. With the bypass valve closed and the engine
running, slowly move the directional control
in both forward and reverse directions (5 to
6 times). Check the oil level, and add oil as
required after stopping the engine.
4. It may be necessary to repeat Steps 2 and
3 until all the air is completely purged from
the system. When the transaxle operates
at normal noise levels and moves smoothly
forward and reverse at normal speeds, then
the transaxle is considered purged.
© 2015 HYDRO-GEAR
Instruction Sheet 670246
Printed in USA 0815
TURFCO MFG. INC.
1655 101
st
Avenue NE • Minneapolis, MN 55449–4420 USA
Phone (763) 785–1000 • FAX (763) 785–0556
Internet - www.turfco.com E-Mail - service@turfco.com
**Total Volume is approximately 4 quarts to get to the low
level mark in the expansion bottle**
**While purging operate engine at lowest rpm**