20
85872 RevA
TURFCO T3000 APPLICATOR
Keep your left side tire about 2 to 3 inches away
from any walks or drives you do not want product
on. As you start moving ahead, open the trim spray
handle. The trim spray nozzle will spray 3’ to 4’ feet
wide. The spray will start 2” to 3” inches to the left of
the left front tire.
4. Stop after trimming around the entire edge of the
property. Using the same “Trim Spray”, you will want
to make a counterclockwise pass around all objects
on the property.
5. Stop. You will now make another pass around the
property exactly 6 feet out from the trim pass tire
track. Use the “Full Spray” control. When you have
finished this pass you will have a 13 foot band around
the entire property to be used for turning. You are
now ready to spray the lawn.
6. To applicate go straight across the lawn using the full
spray control. As your spray hits the 13 foot turning
band on the side of the lawn, turn off the spray and
make a 180º degree turn. The machine will come
straight at 6 foot from your last tire track. Turn on
the spray, keeping the T3000 6 foot from your last
tire track all the way across the lawn. Continue this
procedure until you are done with the lawn.
SPRAY OPERATION ON THE LAWN
All lawns are different. Most accidents happen when
operators are not familiar with either the machine or
the terrain on which they will be using the machine.
Practice with the T3000 before you try to operate it on
a lawn. Practice in all kinds of conditions for at least
30 minutes. Simulate close quarter operation (i.e.
between a fence and AC unit) before you actually try
it. Climb curbs, get used to operation on mild slopes
and making turns. Be totally familiar with your machine
before you every try to spray product to a lawn. You will
need practice before you become good at the controls
and driving at the same time.
1.
BEFORE YOU GO ON THE LAWN,
fill the tanks
with the product you are going to spray.
2.
BEFORE YOU SPRAY ANYTHING,
go on the
property to be treated and drive slowly around the
entire perimeter. Note or mark all obstacles, holes,
rocks or anything that can be a hazard, harmed by
the machine or cause damage to the machine.
3. Trim out the property to be treated. Use the “Trim
Spray” control handle to operate the trim nozzle. You
will be going around the property clockwise doing
a trim strip around the outer edge of the property.
OPERATION
OP85870-28REVD
FIGURE 16
END
TRIM
AROUND
EDGE
FIRST
ST
AR
T
NO
SPRAY
DURING
180°
TURNS
9 FEET
SPRAY - 9 FOOT EFFECTIVE
OP85872-28
FIGURE 16
TRIM
AROUND
EDGE
FIRST
ST
AR
T
NO SPRAY
DURING
180° TURNS
9 FEET
SPRAY - 9 FOOT EFFECTIVE
END
9’
OVERLAP
