Turf Equipment Z-SPRAY JUNIOR Series, Руководство оператора

Страница: 30 / 64

Operation
C. Return the wand back to its holder.
Important:
Contact an Authorized Service
Dealer if the spreader-sprayer fails to operate
properly.
Cleaning the Sprayer
Clean the spray system after each spraying session.
Important:
Always empty and clean the sprayer
immediately after each use. Failure to do so may
cause the chemicals to dry or thicken in the lines,
clogging the pump and other components.
To properly clean the spray system:
• Use three separate rinses.
• Use a minimum of 5 gallons (19 L) for each rinse.
• Use the cleaners and neutralizers as recommended
by the chemical manufacturers.
• Use pure clean water (no cleaners or neutralizers)
for the
last rinse.
WARNING
Do Not clean spray nozzles by mouth or blowing
through them. Swallowing or inhaling chemicals
could cause serious injury or death.
Replace all worn and damaged nozzles.
Make sure nozzles are installed correctly.
1. Drive the machine to a designated cleaning area.
2. Stop the spreader-sprayer on a level surface, leave
the motion control lever in the neutral position,
and turn off the engine. Engage the parking brake.
3. Fill the tank with clean fresh water and close the
cover.
4. Start the engine.
5. With the motion control lever in neutral position,
engage the pump, and set the engine throttle to
“FAST”.
6. Set the three spray valves to “ON”.
7. Allow the water in the tank to spray out through
the nozzles.
8. Check the nozzles to ensure that they are all
spraying correctly.
9. Remove the wand from its holder and point it in a
safe direction.
10. Squeeze the spray wand trigger to release the
pressure.
11. Return the wand to its holder.
12. Set the spray control levers to the “OFF” position,
disengage the pump, and stop the engine.
13. Clean the strainer located in front of the right
tank. Close the tank supply valve. When removing
the canister, drain any unused chemical from the
line and dispose of it according to local codes and
the chemical manufacturer's instructions.
Important:
If you used wetable powder
chemicals, clean the strainer after each tank
rinse.
g321678
Figure 23
1. Strainer
14. Repeat steps through .
15. Using a garden hose, spray off the outside of the
sprayer tank with clean water.
Note:
Do Not use a power washer to clean the
machine. The high pressure water may force
residual corrosive materials into spreader-sprayer
components.
16. Remove the nozzles and clean them by hand.
Replace damaged or worn nozzles.
17. Allow the spreader-sprayer to completely dry
before the next use.
Spray Calibration/Tip Chart/Liquid
Quantities
Note:
Before using the sprayer for the first time,
change nozzles, or as needed–calibrate the sprayer
flow and speed.
Note:
Refer to the chemical product label for
application rate recommendations.
30