Turf Equipment Z-SPRAY JUNIOR Series, Руководство оператора

Страница: 19 / 64

Operation
Spread On/Off
Located on the right side of the control tower and is
the top cable (see Figure 6)
Pull the handle up to open the hopper gate. Push the
handle down to close the hopper gate.
Spread Pattern Control
Located on the right side of the control tower and
is the middle cable.
This control is used if the spread pattern is skewed or
dispensing too light/heavy to one side.
Rotate the handle counterclockwise 90 degrees to
unlock. If pattern is heavy to the left; push the handle
down; if heavy to the right, pull the handle up. Rotate
the handle clockwise 90 degrees to lock.
Spread Deflector Lock
Located on the right side of the control tower and
is the bottom cable.
Use the deflector control to temporarily stop or
deflect granules away from sidewalks, parking lots,
patios, or anywhere granules are not desired to be
discharged from the left side of the spreader.
Push the knob down to lower the deflector and
temporarily deflect the granules.
Pull the knob up to raise the deflector.
g312556
Figure 9
1. Fence 3. Side deflector lowered
2. Flowers
Rate Dial and Linkage
Located at the front of the machine below the
spreader hopper.
The rate dial and linkage is used to set the amount of
material to be dispensed from the hopper gate (see
Figure 10).
g027033
Figure 10
1. Slot–maximum position
2. Linkage
With the Spread On/Off handle in the “OFF”
(closed) position, turn the dial to the appropriate
setting. When the Spread On/Off is pulled to the
“ON” position, the gate will open to the set position.
Note:
The slot, after setting 9 on the dial, allows the
hopper gate to be opened to the maximum position.
This setting can be used for dry sand, ice melt, or
other materials that are difficult to spread; it may
also be used for hopper cleanout (see
Cleaning the
Spreader section).
Caster Wheel Lock Foot Pedal
Located on the right side of the operator platform
(see Figure 6).
Press and hold the caster wheel lock foot pedal to
lock the caster wheels in the straight position. Release
the foot pedal to unlock the caster wheels and allow
the machine to freely turn.
19