Operation
After Operation
General Safety
•
Park machine on level ground, disengage drives,
set parking brake, stop engine, remove key or
disconnect spark plug wire. Wait for all movement
to stop and allow the machine to cool before
adjusting, cleaning, repairing, or storing. Never
allow untrained personnel to service machine.
•
Clean the machine as stated in the Maintenance
section. Keep engine and engine area free from
accumulation of grass, leaves, excessive grease
or oil, and other debris which can accumulate
in these areas. These materials can become
combustible and may result in a fire.
•
Frequently check for worn or deteriorating
components that could create a hazard. Tighten
loose hardware.
Transporting
Note:
Refer to the chemical warning product
label(s) before transporting the machine and follow
all local/state/federal requirements for transporting
chemicals.
Note:
Make sure the spreader hopper cover is secure
before transporting.
Transporting the Machine
Use a heavy-duty trailer or truck to transport the
machine. Ensure that the trailer or truck has all
necessary lighting and marking as required by law.
Thoroughly read all of the safety instructions.
Knowing this information could help you, your
family, pets, or bystanders avoid injury.
To transport the machine:
•
Lock the brake and block the wheels.
•
Securely fasten the machine to the trailer or truck
with straps, chains, cable, or ropes. If possible,
both front and rear straps should be directed
down and outward from the machine. Only use
the four designated tie-down locations on the
machine-two on the left side and two on the
right (see Figure 24). Use these locations even
when transporting the machine with an attached
accessory. Using non-designated locations may
cause damage to the machine and/or attachment.
g317044
Figure 24
1.
Tie-down location
•
Secure a trailer with safety chains.
WARNING
Securing the machine on any upper frame
location will cause the parking brake to not
function properly, which could cause serious
injury or death.
Only use the front tie down locations on the
lower frame to secure the machine.
WARNING
Driving on the street or roadway without turn
signals, lights, reflective markings, or a slow
moving vehicle emblem is dangerous and can
lead to accidents causing personal injury.
Do not drive machine on a public street or
roadway.
Loading the Machine
Use extreme caution when loading machines on
trailers or trucks. One full width ramp that is
wide enough to extend beyond the rear tires is
recommended instead of individual ramps for each
side of the machine. A full width ramp provides a
surface to walk on behind the machine. If it is not
possible to use one full width ramp, use enough
individual ramps to simulate a full width continuous
ramp.
A steep ramp angle may cause components to get
caught as the machine moves from ramp to trailer or
31
