turck uprox BI10U-M18 Series, Руководство по эксплуатации, Страница: 13 / 32

13
2016/08
upr
ox® S
ensors with IO
-Link I
nt
er
fac
e
“Pulse divider”
The “Pulse divider” function causes the device to output a signal pulse to the control level after
a specified number of actuation pulses. The number of actuation pulses (divider) can be set
between 1 and 128.
The following values can be set for the minimum duration of the signal pulse:
■
Target object ( 0 ms)
■
1 ms
■
10 ms
■
100 ms
NOTE
In the event of a voltage drop the number of actuation pulses is reset.
The output configuration can be selected as required.
4.4.2 Settable properties
Output configuration – Output 1
The following output configurations can be set for output 1:
■
PNP, NO contact
■
PNP, NC contact
■
NPN, NO contact
■
NPN, NC contact
■
Push-pull, non-inverted
■
Push-pull, inverted
Output configuration – Output 2
The following output configurations can be set for output 2:
■
PNP, NO contact
■
PNP, NC contact
■
NPN, NO contact
■
NPN, NC contact
■
Push-pull, non-inverted
■
Push-pull, inverted
■
Temperature indicator (not available in SIO mode and for the “Two switch points” function)
Switching distance
NOTE
The feature is only available for “One switch point” and “Two switch points” functions.
The switching distance can be set for both outputs to 20 %, 40 %, 60 %, 80 % and 100 % of the
maximum rated switching distance. Different switching distances can be set independently of
each other for output 1 and output 2. The switching distance of output 1 must be greater than
the switching distance of output 2; otherwise the switching distance for switching output 1
is set automatically to 20 % greater than the switching distance for switching output 2. If the
device automatically changes the switching distance for switching output 1, this is indicated by
a request for a new data update.