Turbosol T20X, Руководство по эксплуатации и обслуживанию

Страница: 59 / 84

USE AND OPERATION
5
561400 - IS16/09 - EN
59/84
5.11.1 Mains water supply
Connect the water intake pipe to the supply fitting Fig. 5-7.1. Connect the high pressure pipe 1 to the high pressure washer 2
delivery fitting; connect nozzle 3 to pipe 1.
2
A
1
A
3
B
B
Pull the water gun trigger and wait for the water to come out from the nozzle (water not under high pressure); this is used to
trigger the high pressure washer.
Activate the high pressure washer by lifting the selector on the control panel. You can now use the high pressure washer to
clean the machine: pull the trigger to release a water jet at a pressure capable of cleaning the machine encrusted surfaces;
release the trigger to stop the water jet.
At the end of cleaning, deactivate the high pressure washer by lowering the selector on the electric panel.
After disconnecting the nozzle and pipe, drain the water inside them. Store them in a suitable place.
5.11.2
Supply from container
The container must have sufficient capacity to complete machine cleaning; it must contain at least 100 litres, be placed at no
more than one metre from the machine and the suction pipe must be as short as possible. Container and pipe must be properly
cleaned to prevent the circuit from sucking impurities and avoid it being left empty to avoid damaging the high pressure washer.
Connect the container intake pipe to the supply fitting Fig. 5-7.1.
Connect the high pressure pipe Fig. 5-10.1 to the delivery fitting of the high pressure washer Fig. 5-10.2; connect the nozzle
Fig. 5-10.3 to the pipe Fig. 5-10.1.
Open regulator 1 on the water gun.