Turbosol PRO H CL, Инструкция по эксплуатации и техническому обслуживанию

Страница: 30 / 54

30
MAINTENANCE OPERATIONS AFTER 50 HOURS
After 50 hours you must run a fi rst control on the
machine.
R
EAD ALSO THE USE AND MAINTENANCE BOOKLET OF THE ENGINE
.
• Change the engine oil
• Change the engine oil fi lter
• Change the gasoline fi lter
• Change the hydraulic oil fi lter
• Change the compressor oil
• Check the seal of the motor (eventual leaks)
• Check the tightening of the safety and stop bulbs.
• Check the valve adjustment and if necessary regulate
them (see instruction on the engine manual)
• Check the motor support and if necessary tighten them
(see instructions on the engine manual)
• Check the V belts and if necessary tighten them.
5.2 - MAINTENANCE TO BE PERFORMED BY AUTHORIZED PERSONNEL
SERVICING
The machine is programmed to indicate when periodic
maintenance is required:
- the fi rst work is scheduled after 50 hours of operation,
- subsequent work is envisaged at specifi ed intervals
(normally 125 hours).
When the maintenance interval has elapsed the
machine indicates the need for work with the message
“MAINTENANCE” on the display.
This message remains active for 8 hours, after which it
disappears automatically.
To delete the warning after having carried out the
maintenance work, proceed as follows:
- press the (c1) ON/OFF start button
- insert the access code (see page 18)
- press the button F2 (g2) before starting the engine,
the following warning appears:
Press the key F1 (g1) to initialise maintenance again,
thereby making the message disappear.
Press any other key to return to the original display page.
g1
c1
g2
ProH [T: 0175]
MAINTENANCE
Vbat: 11.4
F1 = Maintenance OK