Turbosol PRO H CL, Инструкция по эксплуатации и техническому обслуживанию

Страница: 20 / 54

20
Transporting the mix
Empty the water left in the hopper by opening the plug at
the bottom of the hopper.
Use Nitrile gloves to protect yourself against cuts
and abrasions. Preferably use models certifi ed CE
940072.
Use goggles, possibly with polycarbonate break-
proof lenses, to protect your eyes.
Place the mix into the hopper:
• Start the pump by pressing the ON/OFF button (e1) :
the pump starts pumping the material slurry previously
poured into the hopper.
The direction of rotation of
the mortar pump may be
reversed.
With the button (e1) ON/OFF
pressed, press the key (e2)
ON , which maintains the
reverse direction of rotation as
long as it is held.
The red light (e3) go on when the safety grill in the
hopper is open. When red warning light is on the
agitator stops.
The pressure gauge
(36)
indicates the pressure of the
auxiliary pump that has to be of 20 bar, in case that
the machine is without the high pressure water cleaner
(optional) .
When equipped with high pressure water cleaner, the
pressure gauge
(36)
indicates its hydraulic pressure.
On the pressure gauge of the mortar pump
(37)
you can
read the working pressure of the hydraulic system.
The pressure can vary from 60 a 120 bars depending on
the material used.
• Adjust the pump fl ow rate to the required value using the
“arrow” buttons
(g3-g4)
located on the control panel.
Button
(g4)
increases
the fl ow rate.
Button
(g3)
decreases
the fl ow rate.
The fl ow rate is indicated on the display with a value from
0 to 100 and with a 10-segment bar.
Keep the buttons (g3) or (g4) pressed for fast increase or
decrease of the value.
e1
e3
e2
g4
g3
Reg: >
< 38
37
36