Turbosol PRO H CL, Инструкция по эксплуатации и техническому обслуживанию

Страница: 24 / 54

24
4.5 - CLEANING AT THE END OF THE WORK
Pump the last mix and once you start seeing the agitator
shaft stop the pump.
Shut down the pump
by pressing their respective
OFF buttons (e1) .
Before loosening a joint on the material delivery
hose or disconnecting the delivery tube, ensure
that the pressure gauge shows 0 (zero) pressure and that
there is no residual pressure in the hose.
The operator must be carefully trained before
doing this operation.
Before the opening of a coupling, check that there is no
pressure inside the hoses and that no one stands too
close to the hoses.
This operation, that could be dangerous, must be carefully
carried on by qualifi ed personnel.
Disconnect the delivery hopper and clean it properly.
Disconnect the mortar hose
from the mortar pump and insert a
cleaning sponge ball at
the beginning of it.
Open the hopper plug.
With a jet of water you must fi rst clean the mixer and later
the vibrating sieve.
Close the hopper plug and fi ll it with water.
Start the pump and pump water until it comes out clean.
Stop the pump.
Connect the hoses to the pump.
Start the machine and pump water until the washing
sponge balls come out from the other end of the hoses,
If the sponge ball does not come out it means that the
pressure given by the pump is not suffi cient.
A worm gear pump develops much more pressure with
mortar than with water, therefore you should tighten the
stator clamp until you achieve the necessary pressure to
push out the washing sponge balls.
Hence reset the stator clamp to its original position.
If the hoses are not yet clean, repeat this operation.
e1