Turbosol POLI T, Инструкция по эксплуатации и техническому обслуживанию

Страница: 13 / 32

12
13
Couplings
Check that the couplings are clean and in good working
order.
• Cam-lock couplings
When connecting the hose parts, check that the rubber
gasket
(16)
is present,
fully close the levers.
Hoses Ø 35 x 49 - length 10 or 20 metres
for maximum pumpable particle size of 0 ÷ 10 mm.
16
Hoses
Lay out the hoses, limiting their length as much as possible
(to reduce wear), at the same time checking that they are
in good condition.
During pumping the first 10 m of hose swing back and
forth a few centimetres: it is best to keep this section of
hose raised from the ground and in any case do not let it
rest on sharp edges or abrasive elements to prevent early
wear of the actual hoses.
Only use original hoses and couplings.
The hoses should be fitted by TURBOSOL
PRODUZIONE S.p.A. or by firms expressly
authorised by the same.
Under no circumstances shall TURBOSOL
PRODUZIONE S.p.A. be liable for injury to persons
or damage to property if other than original hoses or
couplings have been used.
Hose anchorage
The hose line should be suitably anchored: use the
provided hose safety straps for anchoring the vertical
sections and if necessary the special hose support upon
arrival at the floor level (optional - code 234.049 + 266.148
+ 266.103 / two pieces).