7 TurboLock TL88
Part 2 - Installing the Latch
KEEP DOOR OPEN AT ALL TIMES SHORTLY BEFORE, DURING AND SHORTLY AFTER INSTALLATION. If the lock is
incomplete or improperly installed, the lock and/or door may become stuck.
• After finishing installation, be sure to use the door at least once to make sure all parts of the lock function correctly.
(Fig. 2)
(Fig. 3)
(Fig. 4)
Step 1.
Insert the latch into the hole and check it. The latch’s plate should sit flush against the edge of the door
(Fig. 2).
If there’s
too much space behind the latch or if it’s sticking out of the door, the latch should be adjusted. If the latch needs
adjusted, move to Step 2. If it doesn’t need adjusted, skip to Step 3.
Step 2.
Hold the front of the latch and the square opening from both sides. Pull or push to extend or retract the latch end as
needed
(Fig. 3).
Insert the latch back into the door.
Step 3.
Check the latch’s bolt and make sure the rounded side faces in. Add 2x Wood Screws and use a screwdriver (not
included) to secure them
(Fig. 4).
Part 3 - Installing the Strike
In most cases, the existing strike plate and setup can be used. If you wish to use the one included with your lock, skip to Section
4.1, Part 3.
