Turbolock TL117, Руководство пользователя

Страница: 18 / 36

18 TURBOLOCK TL117
Step 5. Make sure that the latch pin is vertical and the bolt is extended (Fig. 9).
Vertical
Latch Pin
Fig. 9
1.Switch must point towards the closest
door edge of the lo ck.
2.Change batteries immediately after
receiving first low-batte ry warning.
RESET Left and right
lock switch
Connectors
Fig. 10
RESET
Vertical Inside
Thumb Turn
2x Inside
Screws
1x Inside
Screw
Fig. 11
Step 6. Gently insert the power cable connector into the connector of the inside section to snap them together. Collect the
connected power cable into the slot of the inside section (Fig. 10).
Step 7. Remove the battery compartment cover on the inside section and turn the inside thumb turn vertically with the arrow mark
pointing up before installing . Then fit the inside section over the plate and use three inside screws fasten it to the back of
the door (Fig. 11).
Note the placements for the different sized screws. Make sure all screws are tightened.
Step 8. Add the 4x AA batteries into battery compartment. Then slide the cover down over it.
Do NOT force the cable’s connector end through any part of the lock. Damaging the
connector will make the lock unusable.
Step 9. The lock should now be ready to use. It’s highly recommended to use the default passcode
to test the lock while the door remains open to make sure it works before closing the door.
See Section 6 for information on the default admin passcode.
Cover
4 x Batteries