USE AND CARE INSTRUCTIONS
20
5.
8.
7.
9.
6.
Set Control Knobs to OFF and open the LP Gas tank valve
SLOWLY 1/4 of a turn
. For Natural Gas open the Shut Off
Valve at source.
Push and turn Left Main Burner Control Knob to HI/ .
Always light the LEFT Main Burner first. Press the electric
ignitor 3 to 4 seconds to light the burner.
If ignition does not occur in 5 seconds, turn the Burner
Control(s) off, wait 5 minutes, and repeat the lighting proce-
dure. If ignition still does not occur, turn the burner control(s)
and gas source OFF. Wait 5 minutes for gas to clear and then
conduct a leak test of ALL gas connections and gas sources
as explained in the Use and Care section of this manual. If
no leaks are detected, wait 5 minutes for any gas to clear and
repeat the lighting procedure.
After one Burner is lit, turn the tank valve SLOWLY one
more 1/4 of a turn.
Turn each other burner knob to HI/ to light. Note: When
lighting all main burners, start with the burner furthest from
fuel source location, then light remaining burners in se-
quence moving toward fuel source.
Failure to replace a faulty hose, secure gas supply
connections or to open the Lid before proceeding to
the Lighting Procedures could result in a fire or
explosion that could cause serious bodily injury,
death, or property damage.
WARNING
!
!
Grill Lighting Instructions
Before each use, check all hoses for cracks, nicks, cuts,
burns or abrasions. If a hose is damaged in any way, do
not use your grill before replacing the hose with an
authorized part from the Parts List. Also make sure all
gas supply connections are securely tightened.
Familiarize yourself with all Safety and Use and Care
instructions in this manual. Do not smoke while
lighting your grill or when checking the gas supply
connections.
Make sure that the LP Gas tank is filled.
Open the Grill Lid.
1.
4.
3.
2.
(for BTH2610ALP/NG Models)
Open LP Gas tank
Main Burner
Main Burner
Manually Lighting Your Grill By Paper Match
Lighting Tube
(for BTH3210LLP/NG Models)
OFF
HI/
OFF
LOW
HI/
LOW
To light your gas grill by match, follow steps 1 through
5 of the Grill Lighting Instructions. Then, light the match
and place it through the opening of the Lighting Tube
(See Diagram Below). Turn the nearest Control Knob
to the HI/ setting to release gas. The Burner should light
immediately.
