13
3
Install NG Regulator and 12 Foot Hose (for BTH2610ANG & BTH3210LNG Models)
Install the NG Regulator onto the Regulator Bracket using 2 Phillips Head Screws 3/16"x1/4".
Connect NG Gas Fitting with Hose to the Gas Manifold. Install the NG Regulator Bracket to your
Rear Island Panel using 3 Phillips Head Screws 3/16"x1/2" and tighten using 3 Flange Nuts
3/16" as shown.
Connect the Swivel Nut of the 12 foot Hose to the NG Gas Regulator.
CAUTION: Build your grill island before installing the LP Gas Tank and Partition Panel (Not included in this unit).
Refer to the heights listed in Fig. 4 for constructing your grill island. An island unit is not included with the purchase
of your Grill Head.
Swivel Nut
Vertical Fitting
Gas Manifold
12' Natural
Gas Hose
Phillips Head Screw
3/16"x1/2"
Qty. 3
Part # S112G03081
Phillips Head Screw
3/16"x1/4"
Qty. 2
Part # S112G03041
Flange Nut 3/16"
Qty. 3
Part # S313G03051
A
B
Phillips Head Screw
3/16"x3/8"
Qty. 2
Part # S112G0306A
Flange Nut 3/16"
Qty. 2
Part # S313G0306A
Phillips Head Screw
3/16"x3/8"
Qty. 4
Part # S112G0306B
Flange Nut 3/16"
Qty. 4
Part # S313G0306B
Wing Bolt 1/4"x1/2"
Qty. 1
Part # S233G04084
For Installing the Tank Holder Assembly
(Already installed in Tank Holder Assembly)
Install Tank Holder Brackets, Tank Holder Assembly, and LP Gas Tank
(for BTH2610ALP & BTH3210LLP Models)
4
Install the Bracket with Regulator onto the Island Side Panel using 2 black Phillips Head Screws
3/16"x3/8" and 2 black Flange Nuts 3/16". (See diagram)
Install the Stainless Steel Tube (not included in this unit) onto the manifold. Next, insert the other
end of the Stainless Steel Tube through the hole on the Island's Side Panel. Install the Stainless
Steel Tube onto the male fitting on the Regulator.
Install the Tank Holder Brackets onto the Tank Tray using 4 Phillips Head Screws 3/16"x3/8" and
tighten securely using 4 Flange Nuts 3/16" as shown. Be sure that the flat surfaces of the Tank
Holder brackets are positioned towards the Tank Holder center as shown below.
Insert the A Ring of the Tank Holder into the Tank Holder Brackets. Insert the Bolt on the B Ring
into the Left Tank Holder Bracket as shown.
Place the LP Gas Tank into the Tank Holder so that the tank valve faces the right corner. Tighten
the Wing Bolt to secure the Tank in place.
Install LP Regulator onto the Gas Tank.
Fig. 3
Island Bottom
Panel
A Ring of the
Tank Holder
B Ring of the
Tank Holder
A
B
