5.2.1 User Manual Isoforce
REV 5
01st July 2014
page 47 von 77
TUR Therapietechnik GmbH | Grubenstr. 20 | 18055 Rostock | Germany
Attachments Needed
Dynamometer: Angle Adapter ADL4 and Wrist Adapter ADW1
Chair: Footrest, which is a combination of ADS1 and ADT2 (optional)
Put the mechanical stops to “B” blue and “B” red.
Collect angle ADL4 attachment and the handle grip. Combine them to form the attachment
shown in the picture above.
Attach the combined adapter to the dynamometer by sliding it in the input arm, short side.
Ask the subject to lay on the chair.
Set the axis of the joint rotation. The axis of rotation for shoulder is through the acromium, and
it should be right opposite to the colored dot on the input arm of the dynamometer. To succeed
the alignment you might need to make alterations to the positions of the chair and the
dynamometer. The attachment should be parallel to the subject's trunk.
Ask the subject to hold the handle and adjust the length of the attachment. The best angle to
make this adjustment is a few degrees from full extension.
Check the axis of rotation by asking your subject to perform a full flexion and extension of
his/her shoulder.
Opposite Side
Ask the subject to stop holding the attachment.
While the subject still lays on the chair, slide the chair away from the dynamometer.
