Tunturi Classic Vibration 3.0, Руководство пользователя

Страница: 6 / 28

6 7
PROGRAMS
The V3.0 has 3 predefined programs:
1) Manual
As described above, you can set the values for training
settings yourself (pls refer to the exercise description in the
manual also).
Default starting value is 35 Hz, 30s, and Hi Amplitude.
2) Warming up/Cooling Down
Pre-set values for 1st Exercise Cycle:
30 Hz and 30s, with Low Ampl, and Recovery of 60s,
Pre-set values for 2nd Exercsie Cycle:
30 Hz and 30s, with Hi Ampl, and Recovery of 60s,
3) Massage
Pre-set values for 1st Exercise Cycle:
50 Hz and 60s, with Hi Ampl, and Recovery of 60s,
Pre-set values for 2nd Exercsie Cycle:
50 Hz and 60s, with Low Ampl, and Recovery of 60s,
TRANSPORT AND
STORAGE
Please follow these instructions when carrying and moving
the equipment, because lifting it incorrectly may strain
your back or risk other accidents:
NOTE!
Always switch the power off and unplug the
power cord before you start moving the equipment
around!
Stand behind the equipment. Grip the the handlebar, and
tilt the equipment so that it rests on its tran wheels. Roll the
equipment to move it, on these tran wheels. Lower the
equipment while holding on to the handlebar and remain
behind the equipment all the time.
NOTE!
Tran the equipment with caution over uneven
surfaces, for example over a step. The equipment should
never be traned upstairs using the wheels over the steps,
instead it must be carried. We recommend that
you use a protective base when traning the equipment.
MAINTENANCE
The equipment requires very little maintenance. Check,
however, from time-totime that all screws and nuts are
tight.
• After exercising, clean the equipment with a soft,
absorbent cloth. Do not use solvents.
• Never remove the equipment’s protective casing.
MALFUNCTIONS
Despite continuous quality control, defects and
malfunctions caused by individual components may
occur in the equipment. In most cases it’s unnecessary to
take the whole device in for repair, as it’s usually sufficient
to replace the defective part.
If the equipment does not function properly during use,
contact your Tunturi dealer/ supplier immediately. Always
give the model and serial number of your equipment.
Please state also the nature of the problem, conditions of
use and purchase date. Please check the
Tunturi Warranty booklet.
If you require spare parts, always give the model, serial
number of your equipment and the spare part number for
the part you need. The spare part list is at the back of this
manual. Use only spare parts mentioned in the spare part
list.
TECHNICAL
SPECIFICATIONS
Length 92 cm
Width 86 cm
Height 148 cm
Weight 50 kg
This product meets the requirements of the EU’s EMC
Directives on electromagnetic compatibility (89/336/EEC)
and electrical equipment designed for use within certain
voltage limits (73/23/EEC). This product therefore carries
the CE label.
This product meets EN precision and safety standards
(Class H, EN-957). Due to our continuous policy of product
development, Tunturi reserves the right to change
specifications without notice.
NOTE! The instructions must be followed carefully in
the assembly, use and maintenance of your equipment.
The warranty does not cover damage due to negligence
of the assembly, adjustment and maintenance instructions
described herein. Changes or modifications not expressly
approved by Tunturi will void the user’s authority to
operate the equipment!
WE WISH YOU MANY ENJOYABLE TRAININGS WITH
YOUR NEW TUNTURI TRAININGSPARTNER!