Status: 13.08.2019
Translation of the original Installation and operating instructions nnn
TÜNKERS Maschinenbau GmbH
5.2
Initial Start-up
Employees of the TÜNKERS Maschinenbau GmbH, the system manufacturer, or the operating company
establish the connection according to the circuit diagram/pneumatic diagram and the setup during initial
start-up.
6
Operation
The Machine must only be used according to its intended use (see chapter 1.8 "Intended use"). Specific
requirements and safety instructions apply for the different operating modes of the Machine.
The Machine is run in the following operating modes:
▪
Automatic mode
▪
Manual mode (set-up mode)
The operator/manufacturer of the complete system is responsible for executing the operating modes.
The work involved with the operation, tooling, maintenance, and fault repair can be assigned to these
operating modes.
6.1
Safety instructions
WARNING
Observe safety instructions!
▪
Observe the safety instructions in Chapter 2 "Safety instructions" and in particu-
lar Chapter 2.2 "General safety instructions".
6.2
Operating the Retractable Locating and Expanding Pin SDZ 40 F.
The Machine
doesn’t have any controls.
The Machine is operated via the control of the complete system,
in which the Machine is used.
NOTE
For information on operation, observe the operating manual of the complete system.
6.3
Basic checks before and during operation
Familiarise yourself with your work environment before starting work. Externally check (visually) the
Machine for visible defects at least once per shift. Before starting work, the service and maintenance
intervals must be followed in line with the maintenance schedule.
Before switching on the Machine and during operation, monitor the Machine area for anomalies at all
times. The following features may indicate irregularities the Machine are switched on:
▪
increased noise, noise irregularly occurring/unusual noises.
▪
unusual smell
▪
leaks in the pneumatic system.
▪
reduced performance during operations
▪
incorrectly positioned
Shut down the Machine immediately upon the first signs of any of the above issues. Inform maintenance
staff immediately for an accurate assessment of the technical status.
Maintenance staff must then decide if operation can continue without limiting the functionality of the
Machine. If a failure is expected due to damage, perform repairs immediately.
