Tundra TUNENGCRALEV, Руководство пользователя

Страница: 4 / 8

4
USER MANUAL
TUNENGCRALEV
3. OPERATION
IMPORTANT: Before using the load sling adjuster ensure that you have read and understood the safety instructions before use
Ensure that the Engine Load Leveller is suspended from a lifting system in which all components are capable of supporting the
load to be lifted (including the weight of the Engine Load Leveller itself: 5.5kg).
Confirm that the engine load does not exceed the safe working load of the adjuster.
Position the carriage (A) at the centre of the beam (B) and suspend the adjuster, via the carriage, from the hook or
shackle of the lifting device.
Ensure that the slings / chains/ropes around the load are adequate and in good condition and that the load is directly
below the adjuster.
Attach slings/chains/ropes to adjuster load brackets (C) .
Start to raise load and check whether the leveller beam remains level. If it does not, lower the load and adjust the carriage
towards the end of the beam that was low. Repeat this check and adjustment until the beam lifts horizontally.
WARNING: NEVER ATTEMPT TO REPOSITION THE CARRIAGE WHEN THE ADJUSTER IS UNDER LOAD.
4. MAINTENANCE
NOTE: Only fully qualified personnel should attempt
maintenance or repair of this equipment.
Keep the equipment clean and regularly lubricate the
threaded rod (D) .
Carry out a visual inspection every time the
adjuster is used.
WARNING! The load chains and brackets are made
from special alloy steels and precisely heat treated.
DO NOT weld or re-heat treat the chains.
Depending on the frequency of use and local conditions
the equipment will eventually show signs of wear at
which point it should be replaced.
Overloading or incorrect hooking may distort the
brackets, if this occurs replace immediately.
A
D
B
C