Tundra COLD WASH TUNWAS12-100, Руководство пользователя

Страница: 9 / 20

9
USER MANUAL
TUNWAS12-100
v.1.1
OPERATION GUIDE
IMPORTANT BEFORE USE: Check that all connections, nuts bolts and screws are tight and fixed correctly.
Check Pump Oil Bung and Oil Level
If your washer is shipped with a pump oil transit bung (red) replace it with the yellow dipstick supplied
before use. Check the pump oil sight glass to ensure that the pump oil level is sufficiently within the MIN &
MAX levels using the maintenance procedure explained later in this manual.
Check Water Filter
Ensure that the water filter is fitted on the Water Supply Connection (Inlet) on the pressure washer and that
the filter is clean. A well-cleaned filter will ensure the appliance runs to peak performance and will help to
protect the pump from damaging debris and particles.
Connect the Lance to the Gun
Slot the lance into the gun connector and twist to lock in position securely as shown in (Fig.4) . Select and
fit the appropriate nozzle for your cleaning needs. Further information on nozzle types is included later in
this manual.
Connect the Hose to the Gun
Insert the end of the high pressure hose to the gun using the quick release connection as shown in (Fig.5) .
Connect the Water Supply
Connect the appliance to the water supply using the high pressure hose and quick release connections supplied. The hose connector fits onto
the Water Supply Connection (Inlet) on the pressure washer. The water supply should be sufficient to deliver
15L per minute in order to ensure
efficient pump operation. Do not use the washer on a water supply that is less than 15L per minute to prevent damage to the appliance and poor
cleaning performance. The operating temperature of the water supply should be within a standard range of
1°C - 50°C .
Connect the Appliance to the Power Supply
Ensure that the mains voltage corresponds with the required supply requirements for this equipment (230V~50Hz) . Ensure that the plug is wired
correctly with the correct fuse and an earth connection. It is recommended that the power connection is protected by a Residual Circuit Breaker
(RCB) with a sensitivity of less than 30mA. Do not connect other appliances to the same outlet during operation. Ensure that the Power Switch on
the pressure washer is in the
OFF position before connecting the 13A Plug to the socket and turning on the supply.
Starting the Pressure Washer
1 . Ensure the gun trigger is not pressed or locked. Press the Green (ON) button on the side of the pressure washer.
2. With the water supply turned on, hold the gun trigger down for a few seconds to release any air from the hose. Point the hose at a safe surface
area with the nozzle pointing away from any bystanders.
3. As the water begins to jet from the Spray Gun you can make adjustments to the pressure using the regulator as shown in ( Fig.6.4 ).
4. You are now ready to clean with the pressure washer using your selected nozzle.
WARNING: The maximum rated running time
for the equipment is 30 mins (continuous).
In the event of power failure at any time during
operation always turn the pressure washer
OFF at the appliance immediately.
Fig.4
Fig.5
Fig.6